A synthetic compound for concrete repair. Excellent chemical resistance and wear resistance. Ideal for battery room floor surface preparation for large surface defects and holes.

An undercoat for most metal, concrete and similar substrates surfaces. Superior adhesion, incorporating specially treated recycled rubber material for up to 50% elongation, sufficient to bridge small cracks. A single coating can withstand exposure of up to 50% sulfuric acid. Average coverage is 80 square feet per gallon at 20mil thickness. An excellent choice for use with CAL551-201 and CAL551-220 topcoats

A flexible, low viscosity penetrant, ideal for priming and sealing cured concrete. Excellent for pre-treating poorly finished or rough concrete and prepares metal, concrete and similar substrate surfaces for finish coats.

A finish coating providing excellent wear and abrasion resistance, impervious to lead acid electrolyte composed of up to 80% sulfuric acid for extended periods of time (up to 93% for spill and splash). The high ceramic content  withstands foot and equipment traffic, and is excellent choice for battery rooms and spill containment barriers providing a smooth, polished finish. CAL551-411 anti-slip additives can be mixed with the final topcoat to minimize slip hazards in areas where foot traffic may occur. Average coverage is 80 square feet per gallon at 20mil thickness.

A self-priming industrial maintenance coating with high rubber content offering excellent impact resistance while maintaining flexibility, stretching enough to bridge micro-cracks up to 0.10 inch. Can be used as a floor coating or as an undercoat for CAL551-201 and CAL551-220 finish coats. As a low-cost alternative to other coatings, resistance of up to 75% sulfuric acid solution is maintained when applied properly, meeting the requirements of fire codes. Can be used on metal structures that are subject to vibration or moderate flexing.

Our toughest surface coating, impervious to lead acid electrolyte solution containing up to 80% sulfuric acid for up to 30 days (up to 98% for spill and splash duty), making it the ideal choice for spill dams. CAL551-411 anti-slip additives can be mixed with the final topcoat, making the normally smooth, polished finish skid resistant in areas of high foot traffic. Approximate coverage is 73 square feet per gallon. Also an excellent choice for spill barriers and secondary containment systems. Use with CAL551—102 Primer-Sealer.

A water based adhesive providing multiyear protection for tank chimes, pipe supports, pump bases or other areas where water may be trapped or vibrations may create an environment unsuitable for a rigid film. The preferred adhesive for securing spill containment barriers to floor surfaces. Seals any base, footing, etc.  Can be dispensed from a caulk gun. 

A self-priming industrial maintenance coating with high rubber content, offering good impact resistance, while remaining flexible, stretching enough to bridge micro-cracks up to 0.10 inch. Adheres well to a variety of substrates and tolerates less than perfect surface preparation. Designed to provide 100% solids, zero VOC alternatives to coal tar epoxies, eliminating the user and environmental concern of solvent-based coal tar epoxies while matching or exceeding the protection provided by them. Packaged in a 250g 2-part plastic applicator pouch.